A coaxial cable has great uses in television antenna connections. TV satellite connections also use coaxial cables to connect decoders to the TV set.
you can buy a rf converter from radio shack or if you have a vcr you can run the rca cables to th e input on the vcr and output with coax.(make sure you turn the channel on the vcr to the video input channel
The purpose of using a coaxial splitter is so that one can connect more than one device to a single coaxial line. For instance connecting two TV's to one coaxial line for cable television.
coaxial is useful in the fact that not only is it used by your cable boxes to recieve tv channels but it also can be used at the same time with a modem to receive an internet connection from your isp!
You should be able to connect the RF adapter that came with you NES into the coaxial cable port on your tv even though you probably don't use that connection anymore for your cable or satellite connection. Then all you have to do is put your tv on the antenna/cable input and tune it to channel 3.
If the aerial ends in a coaxial cable, connect an f-type end on the cable and screw it to the back of the tv.
There are two types of cable used for television radio frequency signals: 300 ohm twin lead flat cable and 75 ohm coaxial cable. The twin lead is typically used with a rabbit ears antenna and coaxial is typically used with roof top antenna or cable TV setups.For television baseband video signals coaxial cables are usually used.However for digital television baseband video signals these are not adequate and special cables (e.g. HDMI, DVI, DisplayPort) are used. These cables are typically many twisted pairs in a common shield.answer is Coaxial cable
The only difference would be if the VCR or TV is not digital otherwise it should be fine.
Yes! a coaxial cable can go bad. Yes! you can suddenly lose the signal from an atenna because of a bad cable. A a new coaxial cable may fix the problem as long as the damaged cable is the source of the problem. However if the signal problem is at the tap or one of the splitters in your home you will need to call your cable company to fix the problem.
The voltage is too low.
coaxial
No, but they will have a coaxial INPUT.