no that fender definitely will not fit but i found out when i changed a wreck fender on my 93 ES300, i went with the fender from the same side of another 93 es300. it worked perfectly like they are all the same in that year. the only difference was the color but after i got it painted i started getting laid again.
Remove front passenger seat on Lexus es300?
Yea it will fit. Need some adjusting and slight body work to make it perfect. But to bolt on its a perfect match.
you can replace it by taking it to the shop and they will do it for you.
It is located under the exhaust headers, front and center.
how to change front brake pads on a 1994 lexus es300
A rattle in the right front fender of a Toyota Camry may indicate that you need a wheel alignment. It could also point to a problem with your struts.
The starter for this model is located on the driver's side, at the front of the engine.
It should be right under the exhaust manifold and in front of the radiator. From the front view its in the middle of the engine.
see the answer for removing rotors. stop before removing the caliper carrier. very simple.
On the 1994 Lexus 300es, the thermostat is located in the front of the engine. Look for a radiator hose just below the location of the water pump. The thermostat is inside the end of that hose.
In front of the engine Behind the housing cap theres a small plug which is the temperature sensor. Hope this helps.
There are two O2 sensors on a '94 Lexus ES300. Both are located on the exhaust manifolds. There is one accessible from the front just to the right off-center of the engine, and one is located on the rear of the engine down low approximately centered with the engine. Hope this helps. WB