Sounds like it could be a faulty fuel pressure regulator. Take care. jesse also make sure your intake is passing through your o2 sensor and make sure you dont have a bad o2 sensor. I had the same thing happen to me when i replaced a piece of the intake and by passed the o2 sensor it would start idle fine but when i hit the gas it would die shutter or die. check the rubber boot on the throttle cable. Dirt and debris get in the way sometimes causing the accelerator to stick. Easy fix-just rip the damn suckers off Big flaw and the voluntary recall that was issued on the ignition coils and ignition system could be it as well. There are lots of sites and Zx forums with the stats and symptoms with this as well.
Until it stops.
Looking at the engine on the right ride. Its going to be the round object where the timing cover stops on front of the engine.
Which one? Then my answer, "When it stops working within specifications by the manufacturer."
Press and hold b. if u get attack it stops and u have to start again..
its the center carrier bearing in the 2 peice driveshaft...have it replaced or go to a 1 peice driveshaft
Either your fan belts are going bad or your alternator is going out. If you take a bar of soap and press it against the belts while the car is running, the squealing should stop.
it stops dust going to far in ... it stops water going in to much
Usually vehicle just stops running with no warning
it stops a car when u press the breaks on the car
you have a broken air intake hose the large plastic line going to the air filter
press triangle on the demos name in the network area and press pause. That stops it so that way if there are other things you are trying to down load, the first one on the list that is not paused will start downloading.
The timing may be off, have it checked at a mechanic