The sensor states "check brake lights and brake linings" is this something I can do or must it go to the shop?
I have a 03 gran prix and my brake lights doesn't come on when I go to brake
go to a mechanic
A blow 15 amp fuse in the under dash fuse panel causes that i think it is fuse # 24, goes to csmt or something like that
are you sure it is the brake lights and not the tail lights. if it is the brake lights you most likely have a short some where. go to a auto eletrican It is the brake lights which turn on. Short in the switch or the wiring?
check your interior or instrument panel lights fuse, they usually are all connected and when the fuse blows they all go.
Is it the taillights or the brake lights? If taillights it may be a wiring problem, If brake lights check the switch on the brake pedal
brake light switch is bad
The switch is located at the top of the steering column near the brake pedal. There is a bracket attached to the brake pedal that contacts and opens the switch when the brake is not being applied. Push on the brake the switch closes, and the lights come on. Look up the switch on Autozone.com or equivalent to see what it looks like. It's very hard to spot where it's at. Good luck Answer i believe there is a switch on the brake pedal lever near the top. I will go look on my jeep when I go back outside. Also, the brake light circuit has its own fuse separate from the signal lights.
Those tail lights could be the brake lights you are seeing and that would be a faulty brake light switch or the brake light switch is out of adjustment.
bad or out of adjustment brake switch on the brake pedal arm
Probably a faulty brake light switch or the brake light switch is installed incorrectly.