Remove the retaining cover from your factory stereo. Remove the factory stereo retaining bolts. Slide the factory stereo out. Remove the wiring harness and the antenna cable from the back of the factory stereo.
Remove the 2002 Dodge Durango factory stereo decorative cover. Remove the factory stereo retaining screws. Pull the factory stereo out. Remove the wiring harness and the antenna cable from the back of the stereo.
The factory stereo didn't have an external amplifer.
MAYBE WAL-MART IF NOT A STEREO INSTALL SHOP
All i had to do was by the in dash kit and wiring harness and it should plug right in
you need to pop out the frame and unscrew the radio. You will need a wiring harness for an after market stereo.
Remove the decorative stereo retaining cover. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness and the antenna cable.
If you are looking to install an aftermarket stereo in you Saturn it is easiest to buy the factory wiring harness adapter from your local audio components retailer and not hack off the factory plug. The harness adapter has all wires identified and is included for free if you buy your stereo from Crutchfield.com. good luck
YOU CAN GET A WIRING KIT THAT PLUGS STRAIGHT INTO THE FACTORY HARNESS AT A STEREO SHOP OR WAL-MART FOR ABOUT $15. COMES WITH DIRECTIONS AND PICTURES. HOPE IT HELPS
no you do not. not even if you have the rockford fosgate package. you just wire up the aftermarket harness(95+ nissan) make sure you connect the blue/white wire. that will turn on the factory amp.
Go to Wal Mart or Autozone and buy the harness adapter kit. Wire the connector to your stereo, and then plug the connector in the factory stereo harness and you are done. Easiest and cleanest way to install aftermarket stereos. Cost less than $20. or........ go to www.12volt.com.....right there hey have the wiring diagrams for almost n e thing
if factory wal mart sells wire harness and it does some after market serios