I have a 2000 CR-V and on mine it is Fuse #32 (7.5 amps) located in the interior fuse panel which is behind the little plastic pull-out door on the lower left side of the dash panel. I do not believe there was much of a change between these years and yours may well be the identical. This information is also located in the Owner's Manual.
To change the license plate light on a 2002 Geo Tracker, remove the light lens with a small screwdriver. Take out the old bulb and replace with a new one. Tighten the screws on the light lens.
Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.
Added to that, and assuming that you're asking because your license plate light is out, and because the fuse is the same fuse for the tail lights, then the problem is not the fuse. It's the license plate light itself. === It should be the same fuse as the taillights.
no.
The license plate light bulb on a 2002 Pontiac Grand Prix is replaced by removing the retaining bolts and pulling the bulb out of its socket. A new bulb is then put into the socket and reassembled.
hello i need you help me tell me how to remove the cover light from a license plate i have a ford focus se 2002 to put a new light thanks willie
Probably in line with tail lights.
yes 2002 Ford Focus do have 2 lights on license plate
There should be a connector for the lights above the rear bumper, but you may not want to disconnect it because then your likely to get pulled over for having a faulty license plate light
The license plate lights are located just above the license plate. Open the tail gate part way to make removal easier (unless you enjoy squatting). Remove the Phillips screws and replace the affected bulb.
How do you change the lamp on the license plate of a lincoln ls 2000?
Changing the license plate bulb on a 2002 Lincoln LS is quite simple. You must first remove the license plate first. Then unscrew the old bulbs and screw in your new ones.