answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the oxygen censor located in a 1996 Passport?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel filter located on a 1996 Honda Passport?

The fuel filter on a 1996 Honda Passport is located underneath the vehicle close to the gas tank. The filter will have bolts holding it in.


Where is the speed censor in 1996 Mercury Cougar v'8 located?

The speed sensor is located on the back of the transmission, right before you get to the drive shaft you will see it sticking out.


Where is the oxygen sensor located in a 1996 Honda Accord?

IT IS LOCATED ON THE MANIFOLD. JOSE


Where are the three oxygen sensors located on a 1996 Chevrolet Lumina 31?

where is the oxygen sensor located on a 1997 Chevrolet lumina


Where is the transmission dipstick located on a 1996 Honda Passport?

doesnt have one it is a sealed non serviceable unit


Where is the starter located on a 1996 Honda Passport?

Follow the red battery cable down from the battery to the starter.


Where is the Oxygen Sensor Bank 1 Sensor 2 on a 1996 BMW 328is?

The oxygen sensor bank 1 is located in the exhaust manifold. The oxygen sensor bank 2 on the 1996 BMW 328is is located in the head pipe.


Where is oxygen sensor located on a 1996 Chrysler Town and Country?

A 1996 Chrysler Town and Country has two oxygen sensors. They are screwed into the exhaust on the rear of the engine.


Where are the oxygen sensors located in a 1996 Chrysler Town and Country?

The oxygen sensors on a 1996 Chrysler Town and Country are screwed into the exhaust system behind the engine.


Where is the oxygen sensor of a Kia 1996?

The oxygen sensors are located in the exhaust system on either side of the catalytic converter.


Where are the oxygen sensors located on a 1996 Chevy Corsica?

They are screwed into the exhaust system.


Where is the o 2 censor located on 1996 Chevy truck v6?

They are screewed into the exhaust system/ pipes. There will not be any after the muffler. They are about 4 inches long with an electrical wire on the end of them.