motor heat sensor where is it locasted in a 1996 aerostar ford van
the o2 sensor is located in the exhaust manifold. As you pop the hood and look at the engine, you should see a silver colored heat shield. Unplug the old O2 sensor. Then remove the heat shield. Its easier this way (10 MM bolts). Get a O2 sensor socket and remove the sensor and replace. The rear sensor is located in 1 0f 3 places. Either before in or after the catalytic converter. For this one you just get the O2 sensor socket and remove. (When the engine is cold) Madd Dogg 40/40
The O2 sensor is in the front of the engine. If you look at the exhaust manifold by the heat shield you will see it. It screws into the exhaust and has a single wire coming out of it running back toward the drivers side of the engine. Easy to change
The temperature sensor should be located close to the thermostat and has one wire going to it.
The US is located on the North American continent.
on thw botttom
the bank 1 sensor 1 is located in the header right before the cat ans is easy to access from the front of the car. bank 2 sensor 2 is located after the cat and the heat shield can make it difficult to turn
These fans work off of heat sensors. Your sensor can be failing, replace this sensor. This still does not tell where the sensor is located.
heat sensor
It should be next to the blower motor.
It's the sensor that sticks out of the exhaust manifold. To get to it, you'll have to take off the heat shield. You can see it sticking out of the left side of the heat shield, it's connected to the wires coming out.
Assuming this is a 4.3L engine, the engine temp sensor is located between #1 and #3 spark plugs.