THIS METHOD IS FOR THE AUTOMATIC VERSION. (i guess the manual is not too different)
"AT THE BASE OF THE HAND BRAKE LEVER." THE CENTRAL PLASTIC COVER MUST BE REMOVED USUALLY BY UNDOING 6 SCREWS AROUND THE CENTRAL TUNNEL COVER. LEVER OFF THE COVER AROUND THE GEAR SHIFT LEVER, UNCLIP THE SMALL FASCIA AROUND THE RADIO AT THE BASE OF THIS COVER THERE IS ONE MORE SCREW BEHIND THE FASCIA TO ALLOW THE CENTRAL TUNNEL COVER TO BE REMOVED ONCE THIS SCREW IS UNDONE. THE ADJUSTMENT SHOULD NOW BE ACCESSIBLE.
the switch needs to be adjusted
in the cabin under the parking brake
It should be under the dash on the drivers side.
If you do not have your car turned on the vehicle will not shift out of park. You also have to have your foot of your brake.
It is located under the hood below or beside the brake booster.
it would be the brake light switch about 20 dollars at autozone
If the rear brakes are out of adjustment,the hand brake will not work..
Get your brakes checked. It can be something simple, or it can mean impending doom.
quoted $300 for front brake pads, figure I can do no own for less
It turns. There is a special tool for it. You may damage the caliper by pushing straight in.
More than likely DOT3. It is listed on the master cylinder fill cap.
Chjeck the brake light switch located somewhere on the brake pedal lever.