It is mounted below the carburetor on the right hand side.It has three 10 mm bolts and one vacumm line and one electrical connector going to it.It is big enough to fit in your hand.It is round in shape and I would recommend removing the air cleaner housing simply to better access it as I do.When doing this remove the 3 bolts holding the air cleaner on the valve cover and the two nuts at the air filter,also remove the plastic tube for fresh air.Then prop up the air cleaner with a flat head screw driver and remove the two vacumm lines and you will be able to better see and access the egr.Use either brake cleaner or carb cleaner to clean it and use a wire brush/sand paper to remove carbon.Note make sure you reinstall the metal gasket exactly back in place as it was.(it should have a groove worn into it just do to age to help)Hope this helps.
where is the EGR valve on a 1989 mazda b2200
This has been answered and do a seach and it will take you step by step and word it just as you placed your question about it!
Were is the egr on a 1992 mazda protege
Were is the egr valve on a 99 Mazda progege 1.8
The EGR valve is connected above the water hose on the 2002 Mazda Millennia. The EGR valve is responsible for lowering the temperature of the fuel.
There is no egr valve on a 1990 Mazda MPV 6 cylinder
I Called the Mazda dealer today and talked with the Mazda Tech and asked him the location of the EGR valve on the 1992 Mazda b2600i. According to the tech only the California models have an EGR valve, I would think that any state with similar laws about vehicle emmisions would require the egr valve also. My truck is from Montana and it doesn't have an egr valve which explaines why I havent been able to find it.
The EGR valve is located at the right rear corner of the intake manifold, near the firewall. before unbolting the EGR valve, disconnect the vacuum line. - Mazda Repair Manual
how much does it cost to replace to egr valve on the 2002 mazda protege
no
2 dollars
With 2.5 engine it will be on the rear lower of back head. It is an electronic EGR valve with a 6pin plug going to it.