it is just on the outer case of hvac module,and connected with wiring harness and near to the blower motor of hvac
The 2001 Nissan Quest blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.
i am looking for the location of a heater blower resiter on a 1996 Nissan Serena
Its located on the passengers side under the dash in the blower housing............
They are generally found close to the blower motor.
The blower motor resistor on a 1993 Nissan Altima is behind the glove compartment on the passenger side of the vehicle. To access the blower motor resistor, the glove compartment can be removed by lowering the bottom as much as possible and removing it from the hinges.
The 1999 Nissan Sentra has a blower resistor in the air vents. This mechanism regulates the amount of air entering the cabin.
Its to the left of the blower motor under the dash on the passengers side and it should be held in place by a small screw and or its just a pull out type.....
The blower motor fan cools the resistor so the resistor is usually located close to the blower.
To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.
The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it.
If it looks the same as the European Sunny the resistor is located on the (right hand drive) passanger side. Under the dashboard (or under the glove box) the blower is located. The resistor is located in the blower housing (so the heat is blown away). The resistor is connected by a 4 pin long connector. Pull this one out and unscrew the 2 screws that are located near the 4pin. Then you can get the whole (creditcard) resistor out. Replacing the resistor in Holland costs about 60 euros, but in the us the come around $15.