On Asian Cars, bank one is the passenger side and bank two is the driver side. (Japanese drive on the right side of the road.) 2000 V6 Xterra should only have three oxygen sensors (two front, one rear) but later models should have four. Verify this with your Nissan parts guy with your VIN. If yours has California (or 50-state) emissions, yours may have four in which case you need to know whether the code you pulled is for front bank two or rear bank two.
Th knock sensor on a 2002 Nissan Xterra 3.3 is located on the top of the engine. It is mounted under the engine intake.
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin
around $1000 us
Your knock sensor is located undernesth the air intake manifold on top of the engine block. This goes for 2000-2004 xterra V6 3.3L models. Hope this helps.
That sensor is located on the upper bell housing of transmission.Or top front of transmission hard to get to.
Were is location speed sensor
Under the upper and lower intake manifolds at the back of the engine block.
If the Nissan truck is either a V6 or a V8, the oxygen sensor will be located in the manifold. Sometimes it will be placed just below the manifold.
CKP Crankshaft Position sensor
The upstream oxygen sensor is located in the exhaust pipe between the exhaust manifold and the catalytic converter The downstream oxygen sensor is located at the catalytic converter outlet
camshaft location on a 06 xterra bank 2
the tps is in differant places on cars and trucks, but most are on side of throttle body at throttle plate.