There isn't one. The tension for the serpentine belt is an automatically spring loaded tensioner on top of the engine in the front. Place a 3/8 inch ratchet in the square slot of the tensioner arm and pull it back to releive tension on the belt. Then when you put the new belt on pull it back to get it on the pullies then release it to tension the belt.
Remove the alternator from below the vehicle. 1. Disconnect the positive battery cable. 2. Disconnect the 4P or 3P connector from the alternator. 3. Remove the terminal nut and the WHT wire from the B terminal. 4. Remove the adjusting bolt and through bolt nut, then remove the alternator belt from the pulley. 5. Pull out the alternator through bolt, then remove the alternator. 6. If necessary, remove the mount bracket bolts, and the upper and lower mount brackets. 7. Adjust the alternator belt tension after installation. The deflection should be between 6mm to 8.5mm for a new belt.
How to change the alternator in a 1989 Honda accord lx
Either you might use a universal socket attachment or just loosen the large bolt on the alternator. Move the alternator slightly on the pivot enough to get the ratchet in to comfortably loosen and re-tighten the spark plugs. However, marking the starting position of the alternator before loosening may be wise. So as to more closely reposition back to proper belt tension afterward.
The power steering pump and the alternator are mounted in the same way, they have a pivot bolt (like older cars) and a bolt that holds the position adjustment for proper belt tension, but Accords also have a third bolt that sets the adjustment, instead of holding it by hand while the mount bolts are tightened. Start here: Disconnect the high pressure power steering hose from the top. Leave the lower connected so as not to lose the fluid. Remove the nut on the under side of the power steering pump. Loosen the pivot bolt on top of the pump. Use a 10mm socket to loosen the adjustment screw, then remove the bolt from the tab that holds it. The pump should now be loose enough to push it down and to remove the belt. Remove the bolts and adjuster to move the pump out of the way enough to access the alternator. Remove the belt from the alternator the same way. Disconnect the battery, and wires to the alternator. Remove the bolts and adjusters and remove the alternator.
No there is not. The only located on the alternator is the voltage regulator.
Is the alternator actually working. It is possible to buy a new alternator that is defective.
The 1999 Mazda 626 alternator is located on the right hand side of the engine. The alternator will be near the front of the engine.
bolt pattern for what , head, transmission paqn, oil pan ?
Around $100 - go to www.google.com and type this sentence -> price alternator1999 civic lx It will give you prices.
Most vehicle diodes are located in the alternator.
14 mm
5 X 108