on 1998 Camry turn key on push and release alarm button turn key off then start
The 1991 Toyota Camry has an alarm system button below the steering column. The ignition must be turned on and the button pressed for 30 seconds to deactivate the alarm.
The rear struts can be removed, on your 2005 Toyota Camry, by removing the nuts on each end of the strut. With the nuts removed the strut should slide off of the stud.
1990 Camry 4 cylinder thermostat is located off the bottom intake hose connected to the engine block.
The R off button beside the TC (traction control) is the reverse sensor and beeper.
press the off button
This is how to reset "Maintenance Required" light on Toyota Camry with "Smart Key" feature.This works on 2007 and newer Camry models, including the Camry Hybrid. Put the odometer on "Trip A." Turn off the car, hold down the odometer button and, without putting foot on the brake, push "Start" button twice (while continuing to hold down the odometer button). Watch the display . . . it will speak for itself.
This is how to reset "Maintenance Required" light on Toyota Camry with "Smart Key" feature.This works on 2007 and newer Camry models, including the Camry Hybrid. Put the odometer on "Trip A." Turn off the car, hold down the odometer button and, without putting foot on the brake, push "Start" button twice (while continuing to hold down the odometer button). Watch the display . . . it will speak for itself.
there will be a small button below the gear shift stick.... on the stick itself.. just click that button.....
I have yet to do this on my 2005 Camry, but according to the Toyota Tech you must turn the key switch over (do not crank car) the check engine light will appear, now hold down the button on the odometer and at the same time turn the switch off than back on.
Hi. I'm assuming that the od light is illuminated. Your Camry has a three speed automatic with electronic overdrive,(4th gear). This is activated by a button on the T bar under the button you press to select P R D etc. If the dash light is on, then overdrive is off. If you press the button as mentioned and the light still stays on, then there is a problem. Hope this helps.
Try the trunk release on/off button located in the glove box. If this button is in the off position then the trunk release button will not work.