0
Add your answer:
Earn +20 pts
Does a 2003 Mazda Protege LX have an IAT Sensor?
what is your ?, a MAF is basicly a IAT The Mazda Protege and Protege 5 2.0L engine has an IAT Sensor located just past the factory air filter box. It is a two wire sensor that plugs into the intake tube via a rubber grommet. The three wire plug in the Mass Air Flow Sensor. DO NOT Unplug either of these sensors while the vehicle is running or key turned to accessory. Will cause a flag in the computer and turn on the Check Engine Light. Hope this helps.
Where is the IAT sensor on a 02 Protege?
The Mazda Protege and Protege 5 2.0L engine has an IAT Sensor located just past the factory air filter box. It is a two wire sensor that plugs into the intake tube via a rubber grommet. The three wire plug in the Mass Air Flow Sensor. DO NOT Unplug either of these sensors while the vehicle is running or key turned to accessory. Will cause a flag in the computer and turn on the Check Engine Light. Hope this helps.
Where is the MAF sensor located on a 1990 Isuzu Trooper 5 speed 2.8 liter v6?
The 1990 Isuzu 2.8 liter engine MAF sensor can be found on the firewall in the engine compartment. The sensor will be on the passenger side of the firewall.
Air temperature sensor on a 2004 silverado 4.8l?
The intake air temperature sensor on a 2004 Silverado is located in the 5 wire MAF sensor coming from the air fiter box. It can be relocated by cutting and splicing the tan and black wires going to the MAF sensor.
Where is the mass air flow - MAF - sensor located on Ford lightning 1995?
Removal & Installation (4.6L & 5.4L) 1. Disconnect the negative battery cable. 2. Release the air cleaner clamp and separate the air cleaner halves. 3. Remove the grommet from the air cleaner housing and slide the grommet down the hardness. 4. Remove the (MAF) sensor plate and (MAF) sensor from the air cleaner. 5. Detach the (MAF) sensor from the harness. 6. Remove the retaining nuts and remove the (MAF) sensor. 7. Installation is the reverse of removal.
How do i Replace mass air flow sensor Lincoln LS?
1) Disconnect the battery.2) Disconnect the wiring connector from the MAF sensor.3) Loosen the air cleaner outlet tube clamp.4) Release the air cleaner cover clips and remove cover.5) Remove the bolts and the MAF sensor.6) Re-installation or replacement of the MAF sensor requires a new gasket.
Where is the camshaft sensor CPS in a 1.6L 5-speed 2000 Mazda Protege?
on the cover of the timing belt
Where is transmission shift solenoid located on a 2003 Mazda protege 5?
02 protege5,2.0 inside the tranny ,they're 4 or 5.
Is there a map sensor on a 1996 ford 4.9 liter ford engine and where is it?
Removal & Installation (4.6L & 5.4L) 1. Disconnect the negative battery cable. 2. Release the air cleaner clamp and separate the air cleaner halves. 3. Remove the grommet from the air cleaner housing and slide the grommet down the hardness. 4. Remove the (MAF) sensor plate and (MAF) sensor from the air cleaner. 5. Detach the (MAF) sensor from the harness. 6. Remove the retaining nuts and remove the (MAF) sensor. 7. Installation is the reverse of removal.
02 Mazda pro 5 e brake cable loose?
HOW DO I TIGHTEN EMERGENCY BRAKE CABLE ON A 2002 MAZDA PROTEGE 5?
Can a mass air flow sensor be cleaned on 2000 Lincoln navigator?
Removal & Installation (4.6L & 5.4L)1. Disconnect the negative battery cable.2. Release the air cleaner clamp and separate the air cleaner halves.3. Remove the grommet from the air cleaner housing and slide the grommet down the hardness.4. Remove the (MAF) sensor plate and (MAF) sensor from the air cleaner.5. Detach the (MAF) sensor from the harness.6. Remove the retaining nuts and remove the (MAF) sensor.7. Installation is the reverse of removal.________________________Also check related links below
Where is the IAT sensor on a 1997 Dodge Avenger 2.0 L 5-speed?
It is in the same housing with the MAF by the air filter box.
