answersLogoWhite

0


Best Answer

Driver side

User Avatar

Wiki User

βˆ™ 13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is bank 1 sensor 2 on a 2000 Isuzu trooper located?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the thermostat located on a 2000 Isuzu trooper?

The thermostat on a 2000 Isuzu Trooper is located on top of the engine, below the upper radiator hose. It controls the flow of coolant to the radiator and throughout the vehicle.


Where is the obd on a 2000 Isuzu trooper?

The 2000 Isuzu Trooper OBD 2 port is behind unmarked panel over hood release


Where is the idle air control valve located on a 2000 Isuzu Trooper and how do you change it?

above the throle body


Will a 3.5L 1998 Isuzu Trooper engine fit on a 3.2L Isuzu Rodeo transmission?

will a 3.2L 2000 Isuzu Trooper engine fit a 3.2L Isuzu rodeo transmission


What is the towing capacity of a 1989 Isuzu trooper?

2000 pounds


Where is the PVC located in a 2001 Isuzu Trooper?

If like my 2000, it is on the left valve cover. it is too cold to go out and double check.


What keeps rattling after hit a pothole in 2000 Isuzu trooper?

Struts


How do you add transmission fluid to a 2000 Isuzu Trooper if there is no dipstick?

I have a 1994 Isuzu Trooper and it has issues upshifting at lower speeds. How do I check the fluid level in the transmission when there is no dipstick?


How many quarts of transmission fluid does a 2000 Isuzu Trooper take?

When changing the filter and fluids of a car, it is important to know the fluid capacity. A 2000 Isuzu Trooper uses 9.1 quarts of transmission fluid.


Is the 3.5 liter motor in the 2000 Isuzu trooper an interferance?

No - it is not an interference engine.


What gas octan shoud you use for Isuzu trooper?

I have been using REGULAR in my 2000 3.5 Trooper and never had a problem.


How many oxygen sensors does a 2000 Isuzu trooper have?

If the Trooper has the 3.5L v6, there are 4 SO2 sensors. There are two banks right and left, or bank 1 and bank 2 respectively. Then there is a sensor upstream from the catalytic converter on each bank (sensor 1) , and one down stream (sensor 2).Hope this helps/