Sure.. just pull the wiring harness to run the EFI. the carb motor harness wont run the efi.. yes it will. i did it in my truck
The purpose of the wiring harness is to help keep wires together instead of hanging freely. You can purchase a new wiring harness at any auto repair shop.
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
You will need to remove the retaining ring from the top of your 1975 Chevrolet pickup truck ignition cylinder. Slide the ignition cylinder out and remove the wiring harness. Reverse the process to install the new ignition cylinder.
in the wiring harness
The 1999 monster truck stereo wiring diagram can be obtained from most Mazda dealerships. The stereo has a wiring harness consisting of five wires.
Everything will swap over alot of work involved though.. trannys have to be swapped to also the computer and the wiring harness.
The fuel filter is located on the firewall on a four cylinder 1995 Toyota pickup truck!
Answerno the wiring harness in your 92 model truck will not fit correctly into the newer dash. to replace the dash you are going to have to change over the wiring harness, both doors, and the steering column.
this is the proper
.32
gross vehichle weight on a Toyota truck