answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where can you find the idle screw on Nissan Pulsar st-l N16?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you adjust idle on a 1990 Nissan 300ZX?

There should be an idle screw right by or under your throttle


Where is the engine idle adjuster on a Nissan Micra 1991 reg?

micra idle adjustmentThe idle screw is under the auto choke unit, Philips screw head.


How do you adjust idle speed on 1994 Nissan pickup?

The fast idle-speed on a 1994 Nissan D21 pickup is adjusted by turning the screw on the side of the throttle body. It increases the speed of the engine when the vehicle is idle before completely warming up.


How do you adjust fast-idle speed on 1994 Nissan pickup D21?

The fast idle-speed on a 1994 Nissan D21 pickup is adjusted by turning the screw on the side of the throttle body. It increases the speed of the engine when the vehicle is idle before completely warming up.


Where is the idle adjustment located on a 1990 Nissan Micra?

A cross head screw just below the auto choke unit.


Why would a 1988 Nissan Pulsar run fine after being rebuilt but idle at about 1700 RPM and use twice as much gas?

It sounds as if you may have the timing adjusted wrong. The car should idle at 850 rpm I believe. If you adjust the idle the car should use less gas.


How do you adjust idle on a Honda XR80?

Set idle speed to proper r.p.m, by adjusting the IDLE SPEED SCREW. Turn the IDLE MIXTURE SCREW or the AIR SCREW to for correct procedure, achieve highest speed and best response. The IDLE MIXTURE SCREW (FCR) controls fuel delivery to the idle port and the SCREW is located on the engine side of the carburetor slide. Turning the IDLE MIXTURE SCREW out will make idle and off-idle richer. Turning IDLE MIXTURE SCREW (CR, PWK, PJ, PE) controls the amount of air to the IDLE and SLOW CIRCUIT. This SCREW is located on the air cleaner side of the throttle slide and turning the SCREW out will lean the mixture and turning the SCREW in (clockwise) will richen the mixture.


Where is the Idle screw on a 1990 le baron?

Idle is computer controlled, no adjustment screw.Idle is computer controlled, no adjustment screw.


How is the idle adjusted on a 1994 Nissan Sentra?

How do yu adjust idle in a nissan sentra


How do you repair lawnmower too high idle?

Read the owners manual. find the idle adjustment screw and screw that a little. Wd40 all parts. The speed control cable may aso be causing it to never fully get back to the idle position.


How do you set idle for ATVs?

There is an idle screw on the side of the carb its the one you can turn by hand if you have to use a screw driver its probably not the idle screw. turn it CW to increase and ccw to decrease.


Where is idle screw on impco model e?

A model E converter does not have an idle screw. Your idle adjustment would be on your Mixer, equivalent of the carburetor.