you have to take that bottom radiator hose off to replace it
that depends on what engine the truck has if it is a 7.3 l remove serpentine belt remove bottom radiator hose and dump coolant remove radiator hose from water pump remove water pump install new pump reconnect radiator hose reconnect bottom hose to radiator fill with coolant replace serpentine belt start engine let it get to running temp check coolant leve;
It is located on the engine block where the upper radiator hose connects to the engine. To get at it you need to remove the serpentine belt and alternator.
It is located on the engine block where the upper radiator hose connects to the engine. To get at it you need to remove the serpentine belt and alternator.
I'm not sure if Dodge made a Caravan in 77 but if you have a later one, open the hood and check to make sure that the cowl water drain hose is inserted properly. If that drain hose is dissconnected water runoff will dump directly on to the serpentine belt and cause it to jump off. Think about it, was it raining when the belt jumped? That drove me nuts, been there, done that.
The water pump is attached to the fan. Look for the lower radiator hose coming out of it on the left-hand side under the serpentine belt.
The process may vary slightly depending on the vehicle that the 2.7 Chrysler is in . Drain the radiator. Remove the top radiator hose. Remove the serpentine belt. Unbolt the water pump. Replace the pump, using new gaskets. Install the belt, hose, and new coolant.
Serpentine ( eg 3 looped serpentine)
Serpentine is used in jewellery and carvings
Serpentinite is a rock composed of serpentine minerals.I am going to drive a serpentine road tomorrow.
Check for vacuum hose leaks under the hood, causing the car to run too rich. The Mechanic may have knocked a hose loose or leaned on a hose causing a crack at the connectors while he was changing the belt. It's not difficult to replace an air hose. Take the old hose to a shop and match it up with a new hose. You might have to cut it to fit. If it has a 90 degree bend in the hose, you might just be better off going to a dealer and getting an original replacement with the same 90 degree bend. Be sure and buy band new hose connectors while you are there. Also, Autozone might be able to match the hose up with another off the shelf if you bring it in. They can cut it to the correct length, if they can just match the hose bend with another hose.
Danse serpentine was created in 1896.