0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why would the egi main fuse and egi fuse keep blowing on an '87 Toyota Corolla?
There is a short somewhere.
1988 Mazda rx 7 where is the egi fuse located?
In the engine compartment, on the left side, just forward of the left wheel tower, and just aft of the battery is a covered fuse box with all of the large fuses in it. Pull the cover off. The cover has a legend on it that tells you what fuse is which. The first fuse (closest to the center of the car) is the EGI computer. The second one in is the EGI injectors.
Where is the fuel pump on the 2000 Mazda 626?
this is the 30 amp egi fuse in your fuse box in your engine comp.
Why does my 1996 Mazda MPV EGI fuse keep blowing I previously had some lighting problems after launching a boat?
"Why does my 1996 Mazda MPV EGI fuse keep blowing I previously had some lighting problems after launching a boat?"
Where is the fuel pump relay on a 2000 Mazda 626?
this is the 30 amp egi fuse in your fuse box in your engine comp.
Where is the egi control relay 2000 sportage?
locate the fuse panel under the hood of your sportage. There is two bigger relays in that panel 1. the egi control relay. 2. the fuel pump relay.
Where is the fuel pump relay located on a 1991 Nissan 240SX?
Relay is located in the Fuse /Relay box on the right wheelwell just next to the battery. It is labeled "egi pump". EGI apperently stands for "you'll never figure out what this means", since it isn't referenced anywhere. ---- EGI = Electronic Gas Injector ~Rin5
How can you tell when the egi fuse is bad on a 1988 Mazda rx7?
car will have a hard time starting, or more commonly will not start at all
When was Stan Egi born?
Stan Egi was born in Hawaii, in USA.
When was Egi Melgiansyah born?
Egi Melgiansyah was born on 1990-09-04.
How do you change an EGI valve in a 1997 6 cylinder Chrysler Sebring?
EGI.. do you mean EGR?
Which EGI fuse is the one to pull out when de-flooding a 1988 Mazda RX7?
The "EGI INJ" fuse is the right fuse to pull out. It will stop the injectors from shooting out fuel. After pulling the fuse out, crank engine for 15 seconds, rest, crank for another 15 seconds, rest crank for another 15 seconds, rest, put the fuse back and then crank. engine should basically start. if the engine is still not starting, take out the spark plugs and put oil around the seal,thread area and replace back. Do the same previous procedure mentioned The engine should finallly turn over now and start.
