0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What causes a 1988 chey caprice to stall when it is put in gear?
Is your clutch bad or wearing out ?
If the boat outboard motor starts buy stalls when put into gear what is wrong?
what causes a boat motor 40 hp to stall when it is put in gear
What causes a 1986 Oldsmobile to stall while in gear but runs good while idling?
it maybe just a timing problem
What causes vibrations while coasting in 1st gear on a 1993 Mitsubishi 3000gt VR4?
Bad struts can cause vibrations while coasting in first gear on a 1993 Mitsubishi 3000 GT VR4. A bad tire can also cause this.
Why would a 1995 Mirage stall out when put in gear when the charging system is 100 percent?
if it's an automatic trans, the torque converter could be faulty.
Where is the ECU and how access on 1993 3000GT?
I Have a 1991 3000gt Sl and the ECU Is located Behind the radio and can accessed by removing the side carpet panals for your gear shifter.
What causes a 97 Ford Taurus to stall?
A very low idle can cause a 97 Ford Taurus to stall. Another reason for stalling may be transmission bands sticking, which does not allow the transmission to come out of gear on idle.
Can you stall or is it just harder to stall a manual car while driving at speeds over 40?
It depends on the gearing of the car. If you are in the highest gear and 40mph in that gear is under the idle rpm of that car than you will stall.
Can I use the clutch to support second gear so it will not stall or should I just downshift instead?
Downshift. Allowing or operating the clutch to make it slip causes friction which causes heat which causes premature wear to clutch parts which causes unnecessary repair bills.
Why does car shake and stall?
Travelling to slow in a high gear, so clutch in and lower the gear.
What makes a car stall and not go in gear when the engine is cold?
Check your transmission fluid level and also if the gear chamber is not well greased then it will make them stick causing the vehicle to stall.
What is the meaning of clean stall and dirty stall in aircraft?
A Clean Stall is happens in the aircrafts normal cruise configuration. A Dirty Stall is occurs in the landing configuration, landing gear, slats, flaps in the landing position.
