answersLogoWhite

0


Best Answer

yes , sounds like a good swop

yes , sounds like a good swop

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Swivel hub bearings land cruiser
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does my Nissan Patrol shake?

The most common thing seems to be the swivel hub bearings, they get loose and allow the wheels to wobble


What are hub bearings?

a hub is what the wheel bolts to on the car.the hub bearings are the bearings that allow the hub to turn on the axle. most times they are called axle bearings,


Can you repack the front hub bearings on a 1998 Z71 Chevy pickup 4x4?

The hub bearings in a 1998 Z71 can not be repacked. The bearings are part of the hub, and the hub assembly will have to be replaced.


Where is the diagnostic 16 pin connector on a land cruiser HDJ100R?

under the hub on the right side engine


Are wheel bearings and wheel hubs the same thing?

No, the hub is the outer housing that the bearing sits in. Usually bearings have to be pressed in and out of the hub.


Are wheel bearings and hub bearings the same thing?

In most cases, yes.


How do you replace front bearings on Ford Escape not the hub unit.?

You have to pull that whole assembly apart to get to the bearings. The wheel comes off, then the brake rotor, then you have the hub assembly. The bearings are inside of that.


How do you change the front wheel bearings on a 97 ford contour?

They need to be pressed in. You will have to remove the hub assembly and have a shop press the bearings into the hub.


When should you replace your hub bearings?

When they get noisy.


1993 Chevy blazer 4x4 serviceble wheel bearings or hub bearings?

It has 1 big hub bearing per side and you can not service them. It has factory sealed bearings. If there bad then you must replace the bearing.


What is the Torque setting for Daewoo Matiz hub bearings?

front hub 120nm i think


How do you grease bearings on a trailer?

some have a grease sert on the hub, other wise remove the hub cover, and nut that holds bearings in place, and hand repack,