0
Add your answer:
Earn +20 pts
On an 1988 Mazda 626 how do you stop the hold light from blinking it won't even go into gear?
get a new transmission
What should you do to supercharge your 1998 Mazda 626?
go an a mechanic and tell to him where you can get supercharges
How do you replace a Turning signal bulb in a Mazda 626?
go to your local autozone.
How or where can I get a replacement key for a 1999 Mazda 626?
Go to the Mazda dealer and provide them with the VIN number and they should be able to get a key for you.
How do you replace the distributor on 1994 Mazda 626?
Donate it to GoodWill and get Tax Deduction! Do not buy Mazda. Get a bicycle and go green! haha
Why wont Mazda 1995 626 4cyl go when it is in drive or reverse it shifs into drive but doesnt go and the over drive light flashes on and off?
its a known problem with late 95 to 2001 Mazda 4 cyl 626 which is a ford transmission called CD4E that is the worst transmission in this planet and that's why you don't see a lot of Mazda 626 late 95 and above
How do you replace the distributor on 1994 Mazda 626 DX?
Donate it to GoodWill and get Tax Deduction! Do not buy Mazda. Get a bicycle and go green! haha
1999 Mazda 626 and it wont go into 1 or 2nd gear but will go into 3rd or 4th What could be the problem?
Unfortunately, it sounds like your transmission has gone south. Have it checked by a reputable transmission shop, but don't expect the news to be good (or cheap).
Is the cv shaft passenger side interchangeable with a Mazda 626?
ive bought and installed a 5-speed man.trans on a 96 probe that came from a mazda 626 now the pass. side cv shaft will not go all the way in
How do you reset check engine light on a 1997 Mazda 626?
Go to Advanced Auto. They should be able to.
Why would a 1995 Mazda 626 automatic transmission jump between gears after it has been warmed up and driven?
Mazda 626's from 89-92 were notorious for the transmission failing - I don't know for sure, but it could be the same for you here...You could either replace the whole auto tranny - $1000+ or you could replace the gear discs/plates $250....first take it to a mechanic that is reliable - or you could go to MX6.com - great site for anything mazda!
Why is a 1996 Mazda 626 making a loud ticking noise from right front of the engine It increases in noise as the revs go up but if there is no throttle it's very faint?
it will be your valve lifters common problem for the Mazda 626 engine when they start to get up in the milage
