0
If you are talking about the IAC idel air control valve,It is as simple as disconnecting the electrical connector from the IAC valve.removing two mounting screws and remove the valve from the throttle body.Installation is reverse.Be sure to install a new O-ring. Good luck!
Add your answer:
Earn +20 pts
Install air admittance valve?
I would install an AAV if
Where is the egr valve located on a 1992 Mazda b2600i?
I Called the Mazda dealer today and talked with the Mazda Tech and asked him the location of the EGR valve on the 1992 Mazda b2600i. According to the tech only the California models have an EGR valve, I would think that any state with similar laws about vehicle emmisions would require the egr valve also. My truck is from Montana and it doesn't have an egr valve which explaines why I havent been able to find it.
What is a P1145 code on a 1996 Mazda Protege?
"Intake Valve Timing Control Position Sensor, RH Bank 2" wouldn't think it would be too much to fix on this car.
How would you no idle air control valve bad?
1990 Honda accord ex how would you know if idle air control valve is bad?
Why would there be a ticking from valve area on my 1995 Mazda 626?
?? Lifters not getting enough oil ??
How much would it cost to install a blow off valve?
Depends on where you're installing it.
How and where would you install a shut-off valve on a wall-mount faucet?
I take it that you are mounting it out side, put the shut off valve in side, with a drain on it,
How do you change the valve stem seals on a 1997 Mazda 626 2l?
The cylinder head must be removed. If you go to that much trouble, it would be best to resurface the head and do a valve job.
What would one use a thermostatic radiator valve for?
A thermostatic radiator valve is a valve that is connected to the hot water heating system. It can control the room temperature by regulating the amount of water that goes into the radiator. The valve is able to control this by sensing the temperature of the air.
What valves preffered in the upstream and downstream of a control valve ball valve or globe valve?
That would depend on the application such as high steam pressure and if throttling is needed
Can you install a supercharger and turbo on a 2009 Mazda rx8 renesis engine?
yes, but it would be a complete waste of money to do both
Can you change from tub spout diverter to diverter on the control?
NO - you would have to change valve out
