Set your parking brake, jack the vehicle up (refer to your owner's manual), take off the lug nuts, remove the entire wheel assembly (tire and rim), put the spare wheel on, put the lug nuts back on, tighten the lug nuts - preferably, to manufacturer's specs... if you don't have a torque wrench or know how to use one, you should take it to a service center and have them check the torque on the lug nuts - lower the vehicle, stow away the jack and flat tire, and you're on your way.
How to change your own tires on a stratus. First your car needs to be parked on a flat surface to prevent rolling. Get out your vehicle tool kit. Remove your spare tire, then loosen your flat tires lug nuts, but do not completely remove. Set up your jack so your automobile does not lean. Completely remove the lug nuts. Remove the flat tire. Slip on the spare and tighten in the lug nuts. Remove jack.
If your Honda dealer offers the rubber rings that go on the lug nuts buy and replace them or new lug nuts. They hold the hubcaps tight. You can change them one at a time without a jack. But you should use a torque wrench set at about 90 ft lbs to tighten them.
it should be attached to the lug wrench in the trunk. if not,go to the dealer, we have a universal set that can remove any factory style locks. have them remove the locks and replace the set with a new set...and dont lose the key this time!
Set emergency brake Put a block (chalk) at wheel opposite flat Raise vehicle so weight is off flat tire, but it is still on the ground Slightly loosen lug nuts Raise tire off the ground Remove lug nuts Remove flat tire install replacement tire Install lug nuts "Handtight" Lower vehicle until tire is just touching ground Tighten lugs nuts in a 1-3-2-4 or 1-3-5-2-4 pattern to 100 ft. lbs. Re-check lug nuts Lower vehicle all the way
Usually caused by over torqueing the wheels. If the wheels keep gettign changed over and over and the wheel lugs are tightened by an air gun, sometimes the air guns are set at too much torque and it puts too much strain on the studs and before long either the wheel breaks or the lug and it's usually the lug. When you have wheels put on your car, ask the person doing it to hand tighten the lugs using a torque wrench. If you hear the air gun hammering on the lug nuts that is usually when the damage is occuring. It is possible you coudl have hit a large hole with the wheel and the lug took the shock and broke off, but overtightening lug nuts is a major cause of broekn lugs
how much does a lower denture set cost
Remove the wheel covers if applicable. Place the car in park, and set the parking brake. With the proper size socket and ratchet, loosen the lug nuts, (turn counterclockwise) slightly on the wheel you wish to remove. Jack up the car until that wheel is slightly off the solid surface you are parked on. Place a jack stand under the frame of the car. Remove all the lug nuts and remove the wheel. Reverse this procedure, and Tighten the new wheel lug nuts to 100 Lb/Ft of torque.
how much does allied 310 piece tool set cost
how much is a bandaloom
How much does it cost for a Full set of uppers, with porclean teeth, unbreakable?
a basic drum set could cost from £100 - £160.