Turn igniton to on position and put odometer in trip mode, turn off ignition. Hold trip button in and hold it in as you turn ignition to on position, it will flash Turn off ignition. Maintenance light should go and stay off
Disconnect the battery for about 2-3 minutes. But if you have problems with your engine the light will come again on after some time.
Check engine light or required maintenance light. Procedure for resetting required maintenance light just answered. Check engine light requires an OBD II to determine problem and turn the light off.
Consult the drivers manual. You will find that information in there.
This is how to reset "Maintenance Required" light on Toyota Camry with "Smart Key" feature.This works on 2007 and newer Camry models, including the Camry Hybrid. Put the odometer on "Trip A." Turn off the car, hold down the odometer button and, without putting foot on the brake, push "Start" button twice (while continuing to hold down the odometer button). Watch the display . . . it will speak for itself.
This is how to reset "Maintenance Required" light on Toyota Camry with "Smart Key" feature.This works on 2007 and newer Camry models, including the Camry Hybrid. Put the odometer on "Trip A." Turn off the car, hold down the odometer button and, without putting foot on the brake, push "Start" button twice (while continuing to hold down the odometer button). Watch the display . . . it will speak for itself.
Turn key off. Push mileage reset button. Keep it pushed in while you turn ignition key to on position. Hold for 10 secs...
I have yet to do this on my 2005 Camry, but according to the Toyota Tech you must turn the key switch over (do not crank car) the check engine light will appear, now hold down the button on the odometer and at the same time turn the switch off than back on.
Take the 1992 Toyota Camry to receive a diagnostic test. The machine will allow the test to manually turn of the airbag light and also see what is causing the light to turn on.
hold the speedometer reset button down while you turn the key on for about 15 seconds.
Turn on Ignition - depress gas pedal 3 times
1. Set your ODO to Trip A 2. Turn off ignition 3. Hold ODO button 4. Turn on ignition 5. Hold ODO button until Maintenance Required light stops flashing