I replaced an alternator on a 2002 Nissan Altima but the drive belt is now too loose
even with it having an automatic belt tensioner
To tighten a loose drive belt, find the pully that is connected to the belt. Tighten the pully and then hold the belt in place using the adjuster belt. Check out the related video to see an example of how this is done.
If the wire is loose at a connection, find a wrench that will fit it and tighten it.
If your wipers keep blowing the fuses on your 1998 Nissan Altima, it could be a short or the wrong fuse being used. You may have a short in the wiring or the wiper switch, a bad ground wire, or loose wiring.
the valve cover gasket is bad, or the valve cover is loose
That sounds like a broken or loose strut assembly.
No, tighten it to prevent sparks and a possible fire.No, tighten it to prevent sparks and a possible fire.
These will not damage a 2008 Nissan Altima. I have checked several sites and you can fit up to a 22 inch rim on these cars. Only "damage" I have seen is a recall on 16 inch rims that were made in China where a lug nut will come loose.
Yes because during braking your tire will loose contact with road which will affect our stopping distance. it will also cause waves on the tire and when you do replace your struts you will have a vibration while driving
Your air compressor drive belt is loose, Tighten it up! geterdone
You don't tighten it. It has an idler pulley that keeps the proper tension. If this is an old belt and is loose, then it needs replacing. If you have installed a new belt and it is loose, then either you installed the wrong belt or the idler spring is weak and the idler needs replacing.
Engine seized? Dead battery? Loose or corroded battey terminals? Bad starter solenoid? Bad starter? Bad or misadjusted neutral switch?
How do you replace the flasher on a 1999 Nissan altima?" The Turn Signal Relay in a 2001 Nissan Altima is on the right side of the steering wheel at about knee height. You will have to remove the bottom plastic dash part by the removing two screws on the left and right bottom sides of the plastic panel, then carefully pull the top part until it comes loose. The relay is up under the dash on the right and is attached by a screw. Its a black rectangle box about 2 inch by 1 inch in size with an electrical plug on the bottom. Hope this helps!