0
Add your answer:
Earn +20 pts
How do you set the points on a Mazda B2000 1986?
This truck DOES NOT have points!!You would have the standard rotor cap and distributor for electronic ignition.Just buy new cap/rotor install and DONE.Points have not been on vehicles for YEARS.
How do you set valves for a 400 quadrunner suzuki eiger?
how do you set the valves & what are the adjustments for the valves on a 2007 suzuki eiger 400
What should the intake and exhaust valve clearances be set to on a Mazda b2000?
Manual calls for .012 for intake and exhaust with engine warm. I would go .010 on the exhaust and as low as .008 on the intake, factory lash is a little loose in most mechanics opinion. Set factory and it will be a little noisy, but its your call!
Trying to set the set valves on 350 which valve is the intake and which is the exhaust you have found tdc and set the 1 valves now what?
The intake valves line up with the intake runners on the intake manifold. The exhaust valves line up with the exhaust runners on the exhaust manifold or headers. With #1 at tdc you can set 1,2,5,7 intake and 1,3,4,8 exhaust valves. Rotate the engine one revolution to #6 tdc and set the remaining valves.
When are superheater safety valves set to open?
after the main safety valves are open
Are the valves in a 5.7 350 vortec in the heads?
yes there are 8 intake valves and 8 exhaust valves in the set of heads
How do you set push rod clearence in a 2001 350 chev?
Chevy did not make a 350 in 2001. The last 350 was built in 1999.
How do you set up cam timing on a Mazda 626 2.2L engine?
How do you set cam timing of a mazda 626 l 1.8?
How do you set the ignition timing for a 1996 Mazda Protege and what is the correct timing?
Hoo I set the correct timing on a 1993 mazda protege
How do you distinquish between a valve tap or lifter tap in a 1996 Mazda B2300 pickup?
Well the 2300 is an overhead-can set up. Which means it doesent have push rods or lifters. The cam is what actually pushes the valves open and closed. The cam is set right under the valve cover.
How do you set valves on a 292 straight six?
with tools
What is the valve calibration order on a 1988 Pontiac Grand Am?
the same as the firing order set all your intake valves then go thur again and set your exh. valves.
