trying to set up and program 2003 Nissan altima key fob
Yahoo search 04 Nissan altima speaker and a you-tube link should pop up. 02 and 04 have the same set up so this should work for you vehicle
the doors will only open manually
Twist the thing on the dash.
You use the stick. It has buttons saying cruise on/off use it.
When i accelerate it goes slow i think my timing was set wrong a couple of times not just once
2005 Nissan Sentra 1.5 S: Press and hold the Clock button on the radio. When the hour numbers start flashing, *press the UP or DOWN arrows until the correct hour is displayed. Press the CLOCK button again and the minutes will start flashing. Repeat from * to set the minutes. Press the CLOCK button again to exit the clock setup function.
There is no set mileage. It's easy to get 300,000, even 400,000 out of these cars, but it requires diligent maintenance in order to do this.
Clock operationPressing the CLOCK button displays the clockwith the radio on or off. Press the CLOCK buttonagain to turn off the clock display.Clock set1. Press and hold the CLOCK button for approximately2 seconds.2. The display will show “H-Seek M-Tune”.3. Press the SEEK/TRACK buttonor to adjust the hours.4. Press TUNE/FF·REW buttonor to adjust the minutes.5. Press the CLOCK button again to exit theclock set mode.The display will return to the regular clock displayafter 10 seconds, or you may press the CLOCKbutton again to return to the regular clock display.http://www.altimacoupe.com/download/08-coupe-OM.pdf
You don't re-set or set a clock on a Volvo S60. i bought a 2012 S60 in Springfield, IL. Since purchase the clock either loses time or advances time overnight at any given time. Would you believe the dealer has told me Sweden has never heard of this? Go figure! Owned Nissan's all my life with no problems and now spend more and get this. Very disappointed with Volvo!
To change the clock in a 2009 Altima, first turn the ignition to the accessory position without starting the car. Then press and hold the "Clock" button until the time display starts blinking. Use the "Seek/Track" buttons to adjust the hours and minutes, then press the "Clock" button again to save the new time.
Press and hold the clock button for at least 2 seconds. The hours on the clock will flash. Use either the Tune/FF-REv or Seek/Track button up or down arrow to adjust the hour up or down. Press the clock button again and the minutes on the display will start flashing. Repeat the process. When the clock has been set, press clock again and it will return (stop flashing.) It will return to normal clock display in 10 seconds, or you can press clock one more time and it will return to the regular display setting. These instructions are right out of the owner's manual.