Only do this AFTER you have changed the oil! :') First start the car. Then cycle the odometer reset shaft by pressing it until you get to the oil percentage display. Press down on the shaft for at least 15 seconds or until it starts flashing. Next let up on the shaft, rotate it until it gets to the flashing OIL Percentage display. There may be an "A 1" show up at the bottom of the display. Then again, press and hold for another 15 seconds or so. Then your percentage will go to 100%. Turn the car off and congratulate yourself!
With the engine and ignition off push and hold in the odometer reset button. While holding that button in, turn on the ignition but do not start the engine. After about 5 seconds the light will go off and the maintenance required light will have been reset.
Turn key II position Press & hold Odomenter reset button until service light flashing. Press the reset button again for > 5 seconds The service oil life display will be reset to 100%
It is very easy to reset the oil light after you had an oil change in your 2011 Ford E350. You will just need to disconnect the battery for up to 1 minute to reset the light.
asy
asy
You have to fix the cause of the code that turned the light on. It can than be reset with a scan tool.You have to fix the cause of the code that turned the light on. It can than be reset with a scan tool.
How do you reset the maintenance required light in the 2011Toyota RAV4 with a smart key starting system
how to reset the brake service indicator on mini cooper s 2011
Set it to trip A and hold reset turn ignition off then turn ignition on and maintenance light will flash and your done.
How do u reset a maintence oil light on a 2011 f-250 . . . . on the message center of the instrument using the information buttons to navigate the menu to find settings to reset or the information is in the owner's Manuel.
You will need to take it into a mechanic. They will be able to check out your vehicle and then they can turn off the light.
There isn't a reset. If all tires are inflated to 36 psi and the light is on, there is a failure and you will need to take it in for service.There isn't a reset. If all tires are inflated to 36 psi and the light is on, there is a failure and you will need to take it in for service.