How do you reset security alarm system for 2005 Toyota Solara?

Answer 1

Put the key in the ignition, and turn forward

all the way just before cranking. Then within

5 seconds, locate, press and hold in the

valet/overide button, found under the

dash area, (push button, spring loaded)

until the installed LED (the blinking light)

in your dash area goes on solid,

and the siren chirps once.

(Your valet switch might be the toggle

(on/off) type. in this case, key on,

flip switch in opposite direction,

then turn the key off.)

This should reset the alarm, and reset

the grounded relay on the starter wire,

allowing you to start the engine.

At this point, the only thing working would

be the keyless entry from the alarm,

if it came equipped that way.

Just Repeat these steps to place it

back to usable armed mode.

You may get 2 chirps, confirming it,

and the lights may flash twice as well.

That should do it.

If you want to remove it at this point,

take it to your neighborhood installer

for this, or buy the wiring chart

(Go to: www.vehiclewires.com)

for the vehicle, and reverse engineer it wire

by wire, until safely removed.

If it does not work out this way,

you will have to replace the system

with one you know how to operate

and what to expect. Don't want to

get stuck in a bad situation.