answersLogoWhite

0


Best Answer

(1mz fe)(6cyl)

you remove alt/A.C. belt and the p/s belt hormonic ballancer (TIGHT BOLT ) upper & lower timing belt cover engine torque mount / upper dog bone then a big aluminum housing covers the water pump with 4 12mm bolts that comes off when you jack up the motor 1" then the water pump is held in with 6 10mm bolts and two big long studs that needs to be removed with a stud remover or vice grips then presto your water pump is loose.... then you need to remove both cam gears and the metal housing behind that to actually get the water pump to separate from the block clean and reseal and replace all parts test for leaks and your done! recomend you do the timing belt and the idler pullys and the tensioner if you in there doing all that work and perhaps the cam/crank oil seals if youv got high km/s you will need to do a coolent flush when you done as well

Yourwelcome.John

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the water pump 2003 highlander?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace water pump on Cadillac CTS 2003?

how do you replace the water pump on cadillac cts 2004 3.6


How do you replace the seal on a water pump from 2002 Chevy Avalanche?

YOU DON'T!!! I have a 2003 avalanche and I had to replace the water pump you can't replace the seals!!! It's a defect in the 2001 to 2003 avalanche the seals fail.


Should I replace the timing belt and the water pump on a Toyota Highlander at the same?

Yes, Always change water pump at same time, save ya lots of work later,


Cost to replace water pump 2003 Monte Carlo?

Ebay..!!


What mileage should you change the water pump on a 2003 Toyota Highlander?

At the same time u are doing your timing belt 90000


How to replace the water pump in a 2003 Jeep Liberty?

Take your old water pump out. Take it down to your local parts store Get a new water pump and then put it in.


How much does it cost to replace a 2003 Dodge Durango water pump?

To replace the water pump on your vehicle if you do it yourself would be about $65. To have a shop do it, it would cost $250 to $300.


Replacing a water pump on a 2003 olds alero 2.2 liter?

replace a water pump on a 2004 olds alero 2.2 litler


How do you replace water pump on 2003 5.3L Chevy Silverado Z71?

look in the manual


How do you replace the water pump on a 2003 Grand AM?

To replace the water pump on a 2003 Grand AM, the first step is to loosen the bolts on the old one and drain the fluid into a bucket. After it is drained, remove the bolts and the water pump and all of the hoses connected to it. Then, put in the new pump, reattach all of the hoses, tighten the bolts, and then refill the coolant reservoir.


How do you replace a water pump on a 2003 Chevy Express 2500 van?

Drain the water from your 2003 Chevy Express 2500 cooling system. Remove the belt from the water pump. Remove the water return hose. Remove the water pump retaining bolts. Reverse the process to install the new water pump.


How do you replace fuel pump on 2003 Lincoln navigator?

How do u replace fuel pump on 2003 lincoln navigator