You will need to remove the retaining ring at the top of your 1995 Dodge Grand Caravan ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
It's located on the steering column 2 screws unplug the harnest
It's really easy the switch is in the steering colume.
The switch is on the steering column about 18 inches from the floor under the dash. There are 2 screws that hold it on.
change ignition switch and/or tumbler
It's the ignition switch. Replace it. All will be well.
"How do you replace the fan control switch on a 2002 Grand Prix?"
Replacing a steering column ignition switch on a 2002 Pontiac Grand Prix is not considered a major repair. The task is considered easy but if done wrong could be dangerous. It is best to refer to vehicle manual for the car to ensure proper direction is given.
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
it is located on the steering column
Bad ignition switch.... took me forever and lots of money to find. Replace it and the fan will be fixed.
For a 1988 Mercury Marquis remove bottom shroud from steering column (5 Philips head screws). There is a wire running from the ignition switch to the left side of the steering column; detach it from the coupler (This can be done without a tool). Turn key to ON position until the panel lights come on. There is a small pin near the bottom of the key lock; push it in and pull the ignition switch out (don't panic if the wire seems to be stuck; it will come out). To replace, turn new ignition switch to same position. Push pin on the ignition switch in while sliding it back into the steering column. Reconnect wire and then replace shroud.