0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How many retaining clips in a front bumper on a 2000 Honda crv?
Even the manual doesn't give this information.
How do you replace the front turn signal bulb located on a Honda CR-V?
Its harder to replace the side and indicator bulbs on a crv 01 plate remove grill then remove bumper then remove light cluster then replace bulbs. A lot of work for little bulb you would think it would be easy but it aint............
How do you replace license plate bulb on 2004 crv?
how do you replace a honda crv licence plate bulb on a 2004
Replace rear hub and bearing 1999 Honda crv?
how hard is it to replace a rear wheel bearing 1999 Honda crv. this crv does not have rear axle's in it. thank you
How much will it cost to replace brake pads and rotors on a Honda CRV?
how much does it cost to replace brakes rotors on honda crv
How hard is it to replace a ac heater fan motor in a 97 Honda crv?
The heater in the CRV Honda is not working . How do I fix this
How do I replace rear brake pads on 2002 Honda crv?
Youtube has a video showing how to replaced the rear pads for a 2003 crv (02 crv is the same as the 2003 crv). At youtube type in 2003 Honda crv brake change. The video is very good.
Front wheel bearings on CRV?
The front wheel bearings on the CRV are not integral with the hub therefore must be pressed on at a machine shop. It would be best if you are a novice to consult a manual.
How do you replace the front fog light on a Honda CR-V?
The fog lights on MkI and MkII Honda CRV models are mounted into the front bumper and to gain access you have to remove the bumper. If only replacing one side you can leave the fittings on the other side intact and just slide the bumper out enough to gain access to the rear. The fog light is a robust aluminium unit that is totally waterproof. You will have to remove just 4 self tapping screws and disconnect the wiring and the unit will come out from the back of the bumper. Then there is one screw next to the beam adjustment screw that you remove. The adjustment plate will then pivot and come away leaving you access to the 5 screws that hold the rear plate on the unit. Remove these and the plate and you will reveal the bulb held in by the standard spring wire clip. As usual re-assembly is the reverse. Just did mine to replace the bulb. Andy..
How much does it cost to get a co2 sensor repaired on a Honda 2001 CRV?
I want to replace the co2 sensor in my crv myself is it something I can do?
Is Honda making a CRV for 2010?
Yes they are. You can find more results and specifications about the CRV by going onto Honda's website.
How do you change front signal light bulb on 1999 Honda CRV?
To change the front signal light bulb on the 1999 Honda CRV, pry up the fender fastener to expose the bulb socket. Twist the bulb socket 90 degrees and remove from the assembly. Turn the burnt bulb counterclockwise and pull out. Replace with new bulb.
