0
asfar as I know there is no integra tl
AnswerTrue, but assuming the OP means an Acura Integra, jack up the car, remove the wheels, remove the calipers (two bolts on the back side), and carefully support them by wiring them to the spring (you don't want them hanging by the brake line), and then drill out the rotor screws (because the things always get rusted in there and are impossible to screw out). Then just pop the rotor off (you may need to whack the back side of the rotor with a hammer to break it free of the rust) and put the new one on. Do not replace the rotor screws - they're completely unnecessary. The lug nuts will hold the rotor to the hub just fine. You will need to open the calipers before you slide them on over the new rotor - depending on which brakes you have, you will either do this by turning a very large screw, or by squeezing a button in the center with a C clamp.
Then just replace the calipers, and the wheels. Pump the brakes a few times with the engine on. Then roll slowly forward and hit the brakes. If the car does not stop, do not drive it. Jack it back up and figure out what you did wrong.
Add your answer:
Earn +20 pts
How do you replace front rotors on a 2002 acura 3.2TL?
can you cut the rotors on a 2002 acura
Acura Integra has a g rinding sound in front end?
Could be the sound of your brakes grinding. If it is its time to replace pads and rotors before anything else is needed. -- Ended up being bad wheel bearings in both front wheels. Thanks for the possible solution
How do you replace the front rotors on a Toyota Land Cruiser?
how do you replace the front rotors on Toyota Land Cruiser
Does a 1994 acura integra have rear abs?
No, it does not have ABS front or rear.
How do you remove the Acura Vigor front brake rotor?
How do I remove the front rotors so I can replace the CV joints? .... After removing the brake pads and caliper assembly, of course.
How do you replace the front rotors on a 1996 acura tl 2.5?
Those rotors are pressed on at the factory, they must be cut off and also you will need to replace the wheell bearings. Buy new rotors and wheel bearings (whole hub) approx. $84.00 each. Had mines done by acura dealership paid $ 570.00 you probably could get it done cheaper.
How do you remove a 94 Acura Integra front rotor?
See http://www.ehow.com/how_4506404_replace-rotor-acura-integra.html
Would a 1998-01 Acura Integra front bumper fit on a 1997 Acura Integra?
Yes you just need to change the headlights and bumper lights along with the bumper
Where is the horn on a 1990 Acura Integra?
Try behind the grill but in front of the rad
Is an Acura Integra a rear wheel drive car?
front wheel drive
How do you remove the front bumper on a 1991 Acura Integra?
The front bumper on a 1991 Acura Integra is held on by several mounting screws. Remove all the screws and gently pull the bumper off the remaining mounting clips.
Will acura integer gsr front spindle fit on 96 Honda Civic?
Will acura integra gsr front spindles fit on 95 Honda civic
