how do I replace a power antenna on my jeep Cherokee 1992
pa purr e zaan la wachawa nu khpala ba theek she da kanjere na paydaa
Begin by removing the wiring harness from the bottom of your antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.
Begin by removing the wiring harness from your Volvo antenna. Remove the antenna retaining nuts. The antenna will come off. Reverse the process to install your new antenna.
There are a lot of aftermarket antenna masts that you can get to fit your 4 runner and if you do decide to go with a fixed mast just make sure that you make sure that the wiring harness at the mast doesn't ground out on any metal. Other than that there is no problem with replacing it with a fixed mast antenna.
You can get a new mast for the antenna from any Hyundai dealer. This happens a lot and they usually stock them. If you can get all of the old mast out, it's a rather simple procedure, although it can be tricky to get the antenna to grab the new mast. 1. Remove the nut holding the mast into the antenna (12mm I think). 2. Turn the radio on and pull the antenna mast out. There should be a round disc and a ball on the bottom. If not, you'll need to remove the antenna assembly and take the rest of the pieces out of the antenna. If the disc and ball are present, continue with step 3. 3. Push the plastic of the new antenna mast down into the antenna as far as possible. 4. Have an assistant turn off the radio while you're pushing the plastic into the antenna. 5. If the antenna does not grab onto the mast, return to step 2. Otherwise, continue with step 6. 6. Install and tighten the mast nut. 7. Turn the radio on. 8. Turn the radio off. Your mast should now be properly seated. 9.there is a plastic washer also inside that you will have to force the mast thru to get it the set in the motor ! if you cann't push thru , next step take out motor and remove the tube for antenna, you find in sitting inside make sure connect it back the same it is stting , after that replace in car, have someone turn and off radio,job done
You would need to get a tool to remove the notched chrome piece that holds the antenna mast, or carefully use pliers to unscrew it out. After you remove that, the antenna itself is held by a 10mm bolt. to get to it you'll need to open up the trunk lining near the antenna location and remove that bolt. Then, pull the antenna far enough to disconnect the antenna wire and power. Assuming the antenna motor is still functional, you can then replace the antenna mast with a new one. Or, you can install an aftermarket rubber antenna.
The antenna assembly is accessed from the inside of the trunk by removing the panels. If you just want to replace the mast try this link.How_do_you_replace_an_antenna_on_a_mercedes_300EHope this helps.
You can purchase an antenna mast at most auto shops like Auto Parts or Auto Zone. Many gas stations or garages will also carry the antenna mast for your car.
For 300zx: may help http://www.carstereohelp.org/DoItYourselfRepair/NissanPwrAnt300zx.htm
Take it to the DEALER!!!!!!!!!!!!!!!! Not a fun job worth the money to have them do it for u . Buy it from part store the take it to the DEALER .....
it is threaded onto the mast you must use a small wrench on the 2 flat spots on the base of the antenna. it has right handed threads