Depending on engine it is pretty simple... I have a 2.5L 4Cylinder 1992 Dodge Spirit... First u drain the coolant. Remove Serpintine belt Remove the A/C Compressor and keep it out of the way with someone such as rope or a bungee cord, whatever you might have to keep it up and out of the way... Remove Alternator. Remove the main mounting bracket that holds the AC Compresser and the Alternator. Remove the 3 bolts holding the water pump housing to the engine block. Now all you have to do is remove the water pump from the water pump housing then do this in reverse. Installing the new gaskets and such.
It is inside the engine, driven by the timing belt.
the water pump is on the bottom of the engine underneath the alternator
It is not a direct fit.
I have a 1992 Dodge Spirit and it doesnt have an Egr Valve, but that's for the basic spirit, if you have an es, or anything, it will be located on the Intake Manifold. Its not hard to spot cause they usually say EGR across the top of it.
Remove wheels Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub
front wheel drive
You add transmission fluid down the transmission dipstick hole.
your headlight is probably full of water
You probably need to replace the crankshaft seal
It is in the fuel tank.
You must drop the fuel tank.
Well I don't know about yours, but my owners manual for my 1992 Dodge Spirit with a 3.0L V6, 3-speed automatic transmission says that it has a 60 L tank. Hope that helps.