0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace the clutch in a 1991 Nissan 240sx?
ask the mechanic from the Nissan company
I have bled the slave cylinder on my 240sx and replaced the clutch master cylinder and my 240sx will still not shift into gear. What else can I check?
If you did not bench bleed the master, you need to do that.
Where is the number one cylinder on a 1990 Nissan 240sx?
closest to a fan!
How do you bleed the clutch line on a Nissan 240SX?
The same way you bleed brakes, but use the little bleeder valve on the slave cylinder. The same way you bleed brakes, but use the little bleeder valve on the slave cylinder.
The clutch wont engage on your 1990 Nissan 240sx and the pedal sucked to the floorboard what is the easiest way to fix this problem?
It depends on the type of clutch linkage. If it's mechanical linkage the clutch could be worn and the rod dropped out. If it's a hydraulic clutch, the clutch master or slave cylinder could be worn out.
Bleed clutch cylinder on a 1991 Nissan 240sx still no presure on the padel?
You must bleed the clutch dampener before bleeding the slave cylinder its that weird curvey steel hose before the slave unter the passangers feet. look arount the side of the dampner for the bleed screw
Where is the blade to tighten up the screws for a clutch in a 1989 Nissan 240sx that is slipping?
no adjustment of this clutch only a pedal freeplay adjustment
Problems bleeding the slave cylinder on a 240sx Nissan?
i do not exactly understand the question. there usually are not problems associated with bleeding the slave cylinder on a 240sx transmission, but i will explain how to do it. locate the slave cylinder on your 240sx under the car on the passenger side of the 240sx. you will need a 10mm open-end wrench to loosen the nut on the slave cylinder. loosen it enough that it spins freely, you do not want to loosen it so much that it comes off. you will need a second person inside the car to pump the clutch. loosen the nut on the slave cylinder, have the person inside the car push in the clutch pedal and hold it down, then tighten the nut on the slave cylinder. repeat this process until there is a steady stream of fluid shooting out of the slave cylinder. then you will need to replace the lost fluid with DOT3 brake fluid in the clutch fluid reservoir under the hood, which is to the top back right of the engine bay.
Engine makes noise but stops when you put the clutch pedal in Nissan 240sx?
Probably the through out bearing.
Why will the clutch not pump but will stay all the way up or down in a 1990 Nissan 240SX with manual transmission added clutch fluid?
I would suspect that the clutch slave cylinder is bad. Follow the line down from where you added fluid to find the slave cylinder. After replacing the slave unit you will need to bleed the system then it will work fine again. Mark
If you just replaced the clutch master cylinder on a Nissan 240sx then why won't it build up pressure?
The most likely case would be that air somehow got into the line. try bleeding the clutch fluid, while making sure that the level in the reservoir does not get low.
What is the engine for a 95 Nissan 240sx?
a 95 240sx engine is a 2.4 litre KA24DE inline four cylinder. it's a 16 valve DOHC.
