Disconnect the spark plug wires, disconnect the PCV-valve, remove four nuts holding the cover. Make sure that wires are not in the way. Remove the cover.
how do i remove the valve cover to change the gasket in a toyota camry 1996
just yank on it!
That would depend on many things. The year of your Toyota Camry, engine size, and how you drive.
looking at the engine it's on the left side under the plastic cover... remove the 10mm bolts to access the belt.
There is a cap on the top of the valve cover. If you remove it you will be able to add oil in the engine though the opening behind the cap. Be careful don't overfill the engine.
on the 3S-FE engine, you will have to remove the engine from the car, then pull the cover off where the timing belt is. The water pump is inside there. It's a JOB.
It should be on the top of the valve cover connecting the engine and the injector.
There is no PVC valve on the 4cyl Toyota Camry. ÊThe location of the PVC valve on the 6cyl is center upper engine area, mounted in the rear valve cover.
remove the "dog bone" engine mount. then the 2 upper 10mm bolts on the timing belt cover. this will allow you to pull the harness out of the way to remove the cover.
what is the torque specifications for a toyota camry 4-cylinder valve cover
There is no PVC valve on the 4cyl Toyota Camry. ÊThe location of the PVC valve on the 6cyl is center upper engine area, mounted in the rear valve cover.
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.