the CD shuttle is located on the left side of the trunk floor, its covered with a protective shell that is attached with velcro type pads. remove the cover and you`ll see two electrical plugs on the shuttle, unplug them.. you will then see two 12 mm socket size bolts , one at the front and one at the rear.. remove them. Now if you lift the trunk interior trim that is covering the left portion of the trunk inner side, you will see a nutted stud, use a 10 mm size socket to remove this nut, push the changer to the left and then when the stud disengages from the inner brace, pull the unit straight back... and there ya go.
remove the gas lines on both ends, be careful not to drop your copper orings unless you are installing a new one. then remove the two bolts that have it mounted to the block. and install the new fuel filter and your done.
Mounted on top and inside the fuel tank assuming a t4 is a car or truck.
On Dakota trucks it should be mounted on the right fender. Other pickups probably use the same location.
YOU HAVE TO REMOVE THE GLOVE BOX. ITS MOUNTED ON THE FRESH AIR DUCT.
Remove the water supply hoses from your 1992 Chevy S 10 pickup truck heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.
unbolt it from where it is attached
i have a 1992 lexus ls 400...the cd won't play..you can hear the cd changer ...but no sound
Remove the transmission pan on the bottom of the transmission. The filter is mounted to the valve body of the transmission.
There is no drain plug . you will need to remove the trans. pan to drain fluid.
I have the same truck with a 5.8l, and I imagine it is in the same place... Mine is mounted on the top pasengers side of the firewall.
Will a 1992 Dakota truck motor fit into a dodge truck 1999 Dakota?"
I have a kenwood KDC-C600 Compact disk auto changer the sticker on the back of my changer says 1992 august hope this helps