How do you remove the rear seat on a 2002 diamante
under the passenger seat
fuel pump is located in gas tank, but there is an access panel located under rear bottom back seat,remove access panel , and you can change fuel pump,.
under the back seat
its under the back seat
The Mitsubishi Galant VR4 is an interesting alternative to their Evolution model. It was available as a saloon and estate car. It could seat up to 5 people, depending on whether the 5th seat belt was in place.
its under the back seat. you need to remove the back seat to access it and you'll need a Philips screwdriver and a REALLY tight grip or a hammer to remove it.
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
there are two clips on the front of the bottom back seat cushion that you pull out on and then are able to pull up on the cushion and remove it. There are then four bolts that hold in the seat back. remove them and push up on the whole seat back to upclip it at the top. after this remove the child safety anchors and the rear brake light is held in by two bolts that you can take off from inside the trunk. pull out on the side plastic panels to unclip them from the rear deck carpet piece and then you can remove the carpet piece. the rear speakers are held in by four Phillips screws and use a pretty standard Toyota speaker harness which you should be able to get at any car audio store.
The fuel pump is located in the fuel tank. Fortunately there is an access panel under the rear seat. Once you remove the rear seat, the pump is fairly easy to get to.
If the back of the rear seat can be removed, it may be possible to enter the trunk and open it. If not, then the lock will either have to be picked or drilled out.
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm