0
On my 1.6L Elantra there is a hole in the inner fender that lines up with the crank shaft bolt. Remove the front tire. A half inch drive extension bar will fit right into the recess in the crank bolt. I used my impact wrench and a 1 foot long 1/2" drive extension and the bolt came right out. A 1/2" drive ratchet or breakover bar would work just as well. My problem now is I can't get the crank shaft timing belt gear off. It moves about 1/4" and then hangs up.
Add your answer:
Earn +20 pts
Where is the crank shaft sensor located on a Hyundai Elantra?
in front of the motor by the transmission
Hyundai elantra engine has no compression?
by driving my car the hyundai elantra 01 stall out and i replaced spark plugs , cam sensor crank shaft position sensor and still not ignighte
How do you take off a crank shaft pulley?
how to get the crank shaft pulley off of a 03 Hyundai elanta GLS
Where is the fuel tank pressure sensor on a 2006 hyundai elantra?
In the cam shaft, where else?
Where is the crank shaft sensor 2001 Hyundai sonata 4 cylinder?
its on the front off the engine you must remove timing belt to replace it
How do you remove crank shaft pulley megane?
To remove a crank shaft pulley you need to first jack up the car. Next, remove the bold holding the crack shaft pulley in place and remove the unit. Reverse direction to put the new crank shaft pulley on your car.
Where is a crank shaft sensor located on a 1991 Hyundai scoupe?
on top of the bell housing in plain view
Where is the crankshaft position sensor in a 2002 Hyundai Sonata?
It is behind the crank shaft pulley in front of the motor!
What tool do you need to remove a crank shaft pulley?
12mm /19mm
Where exactly is the 2000 Chevy Impala crank shaft sensor?
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft
How do you replace a cooling fan on a 2000 Hyundai elantra?
1.Remove the radiator and cooling fans as a single assembly 2.Remove the bolts and separate the fan/shroud assembly from the radiator 3.Remove the clip and detach the fan blade assembly from the motor shaft 4.Remove the screws and detach the fan motor from the shroud
Do you need a Crank Shaft Head to put on a Crank Shaft in Lacrosse?
I would recommend that you do put a crank shaft head on a crank shaft. Putting any other type of head on a crank shaft could possibly break the head.
