Remove the tire and wheel from your 1995 Chevy. Remove the brake assembly. Tap on the brake rotor with a mallet or hammer. The brake rotor will slide off.
Remove the tire and wheel from your 1995 Chevrolet K 3500. Remove the front brake assembly. Tap on the brake rotor with a hammer or mallet until it becomes loose. Slide the brake rotor off.
You will need to remove the tire and wheel from your 1995 Chevy Cheyenne. Remove the brake assembly. Tap on the rotor with a hammer or mallet. The brake rotor will slide off. Reverse the process to install the new brake rotor.
Should be "peel off" type Remove wheels Remove caliper mouting bolts Slide caliper off rotor Rotor should slide off hub
The reason that the front brakes on a 1995 Toyota Corolla are not releasing is likely due to low brake fluid. It could also be that the rotor is stuck or the pad has frozen into a clamped position.
EAsy , remove distributor cap then loosen two screws holding rotor down and pull it off . reassembly is reverse of removal
Remove the wheels from your 1995 Toyota Camry. Remove the brake pads by removing the brake pad Springs. Tap on the brake drum with a hammer or mallet. Slide the brake drums off. Reverse the process to install the new brake drums and shoes.
Should be 2 mounting bolts one on top one on bottom remove these and slide caliper off rotor
If they are of the "peel off" type: Remove wheel Loosen and remove 2 bolts that secure brake caliper Remove caliper and rotor should come right off If not "Peel off" type: Remove Wheel Loosen and remove 2 bolts that secure brake caliper Remove caliper Remove center dust cover from wheel Remove cotter pin Remove safety nut remove lock-nut wiggle rotor so bearings fall out and rotor should pull off
Buy the repair manual (Haynes, CHilton, FOrd Factory). Remove the wheel. Remove the caliper. Remove the disc retaining screw. Pull off the disc.
Lift the vehicle with a car jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Next, put in the new brake pad, replace the brake shoe/caliper, replace the car tire, and lower the car to the ground.
Remove the tail light from the outside. Pulls out. Replace bulb. There is no access from the inside of the trunk.