answersLogoWhite

0


Best Answer

To remove the driver side cv axle:

place a large flathead screwdriver between the transaxle housing and the axle. Then place a chisel behind the screwdriver. The order will be: transaxle housing, chisel, flat screwdriver, axle.

Then give the chisel a hit or two with a hammer and it should pop out with ease.

I'm not sure about the passenger side axle but I think you may have to take off the pillow block that is bolted to the transaxle which the cv axle sits in.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove a front axle assembly on an Acura Vigor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove the Acura Vigor front brake rotor?

How do I remove the front rotors so I can replace the CV joints? .... After removing the brake pads and caliper assembly, of course.


How do you replace the wheel bering on a 92 Acura Vigor?

The front bearings on an Acura Vigor are pressed on bearings, unless you have access to a press or know of a shop that can do this for you I wouldn't attempt this job.


Where is the starter located on a 1991 Acura vigor?

The 1991 Acura starter is located near the front of the engine, on the left-hand side. You will find the starter near the bottom of the engine.


How do you replace the thermostat located on a 1992 Acura Vigor?

Remove the top radiator hose from the thermostat housing, its the round thing up front of the motor that the hose leads to it from the radiator. Then remove the bolts holding on to the top part of the housing, replace and reset all parts removed.


How do you change the driver side front turn signal bulb on a 2000 Acura TL?

Turn Signal removal '01 Acura TL Simply remove the fender liner from its usual area around the front wheel, this will give you easy access to the turn signal bulb in the headlamp assembly.


How do you remove oil pan 1999 dodge durango 4 wheel drive?

You will have to remove the front axle assembly to have enough clearance to remove the oil pan in vehicle.You will have to remove the front axle assembly to have enough clearance to remove the oil pan in vehicle.


Where is the diagnostic port for an Acura RL?

remove the front ashtray, it is underneath


How do you remove a 94 Acura Integra front rotor?

See http://www.ehow.com/how_4506404_replace-rotor-acura-integra.html


I have a Leak between the oil pan and the differential on 93 Acura Vigor oil pan side. Anybody had this problem?

i had the same problem with oil leaking too, i tried all kind of stop leak. but only "lucas" oil stop leak worked, haven't leaked since. My 92 Vigor had the same issue. It was initially diagnosed as a leaking oil pan gasket. I brought it to Acura and was advised that the leak came from the oil filter adapter assembly seal and not the oil pan gasket. To access this part, the front differential assembly had to come off along with the return hoses.


Where is the thermostat located on a 1991 Acura Legend?

The thermostat is just under the throttle assembly at the front of the engine. You will need to remove a black plastic shield in order to access it. Is it difficult to remove and replace? Should that job cost $100? Would a failing thermostat cause the radiator to crack,leak and overheat on my 1991 Acura?


How do you remove the front bumper on a 1991 Acura Integra?

The front bumper on a 1991 Acura Integra is held on by several mounting screws. Remove all the screws and gently pull the bumper off the remaining mounting clips.


How do you remove the front bumper light assembly on a 1999 corvette?

== ==