answersLogoWhite

0


Best Answer

Answered in another forum which was specific to Tacoma models 2005 and later.

"I have the same issue - Found a picture of a replacement taillight assembly and the assembly is held in by more than 2 bolts - I'm still trying to find the 3rd bolt - 2 of the bolts are 10mm Hex Bolts at the top and bottom of the Taillight assembly when the rear tailgate is down. This loosens the assy - But somehow a third fasten point somewhen under the wheel well or behind the Bed Liner prevents me from getting it removed. There must be a simpler way to replace the Bulbs?

CORRECTION: To replace a tail light bulb in Toyota Tacoma 2005 2006 tail light

Lower tailgate, on the inside near the latch, remove the upper and lower 10mm bolts, the two without washers. The whole tail light assembly should now be loose, and move in and out a little bit. There are only 2 push-in plastic posts holding it now, so gently but firmly pull the assembly straight back and it will pop out. Wires will still be attached, don't pull too hard.

Twist CCW and pull out the corresponding bulb sockets to replace the blinker, backup, or tail light bulbs.

UPDATE:

Check out the picture of the removed light assembly via the "Related Link" below. Those posts are flared. Meaning they're a pain to remove. It felt like I was about to break the assembly, but as long as you're pulling straight out, you should be fine. There's no other way...."

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove Tacoma tail lights?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Do 2001 tacoma tail lights fit 1999 tacoma?

Yes, they should fit.


How do you remove civic type r tail lights?

you have to remove the bumper in order to remove the lights :)


Brake lights do not work when tail lights are on?

On a toyota tacoma 2003 SR5 when the tail lights are turned on the brake lights come on and when the tail lights are of the brake lights work just fine what could be the problem. If the truck has a trailer plug, inspect the plug and plug wiring for damage and corrosion.


What is wrong if your 95 Tacoma dash lights and tail lights are out and there is no power going to the fuse for dash lights and you heard a click when you were fixing a moonvisor light then they went out?

I have that same problem with a 2001 tacoma no power rear tail lights brake light works and nothing for dash lights i need answers i am stumped Any real answers to this please???


Toyota Tacoma troubleshooting 1996 Toyota Tacoma brake lights not working cab brake light works Tail light bulbs ok?

Yes


How do you remove 2008 BMW tail lights?

with a hammer


How do you remove cover on tail lights on Buick regal?

Get a rock


How do you remove Nissan Sentra tail lights?

You can access the Nissan taillights from the cargo compartment. Remove the tail light assembly cover. Remove the tail light wiring harness. Remove the tail light assembly retaining bolts.


How do you install expedition taillights?

Open rear door hatch. There on top of the rear tail lights you will see two or three screws. Remove those screws and gently remove the tail lights. When your done with the tails lights reinstall.


How do you remove 2010 tacoma tail light?

to remove tail light's. open the tail gate. remove the 2 10mm bolts with out washers on each side..then you must pull the light straight back....it will be tight but their are no more bolts holding it, only plastic tabs..


How do you change the tail light bulb in a 1985 Corvette?

Remove tire and inner fender well and change it from there. Other option is to remove the licence plate and reverse lights,reach through to the tail lights.


How do you remove tail lights in a 2006 civic?

The tail lights on a 2006 Honda Civic are mounted to the brackets in the trunk of the car. Open the trunk and remove the mounting bolts. Unplug the bulbs and the housings will then be able to be removed.