How do you perform a stoppie in your pulsar 150?

Answer 1

Dude, follow the following steps and you'll get a nice stoppie:-

1. Warm up your front discs by simply applying the brake slightly and running your bike.

2. After this, run the bike at a speed of as low as15km/h, in case you apply the disc harshly you may not topple over.

3. Instead of jamming the brakes completely as many people may say, gradually nand slowly increase the braking pressure before jamming brakes completely.

4. As the above step is done, hold your grip tight both on the handle bar and on the fuel tank, and push your bike forward without getting of your seat.

5. If everything goes well, you'll slightly pop yourself a stoppie, not high enough but under safe limits.

6. Please repeat the above stated steps as frequently as you can so that you easily get used upto to them.

7. Once you are used up to them, increase your speed uptill 30km/h. This will make your stoppies higher.

8. When you get familiar with the stopping factors, you can try rollin stoppies by simply increasing your speed and decreasing pressure on the brake lever.

That's all dude, know you are a stoppie king.

Note:

1. Police hates stunting on bikes, so better check you are alone.

2. Check the gripp of the front tyre and that of the road because uneven grip can lead to accidents.

3. Always wear you safety gear cause you won't know when you'll topple over.

4. In case you topple and break yourself and your bike, please for god sake, don't blame me cause I have flipped thrice of my pulsar and dude it really hurts.

Goodluck..............