answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you install neutral safety switch in a 1997 Acura RL?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the neutral safety switch located on a 1988 Acura Legend?

99 acura Ti


Where is the neutral safety switch on a 96 Acura Integra in order to disable it?

The neutral safety switch is located on the clutch pedal. This switched is used so as a safety so the car cannot be start in gear. Reach under the dashboard to unplug the switch from the harness.


How do you change out the neutral safety switch on a Acura Vigor?

This is a complicated switch to replace. My best advice it to pay an auto shop to do it, they will charge about $50. Its complicated because the switch goes onto the transmission, so there's a lot of panels to remove and put back.


Where is the neutral safety switch on a 1994 Acura Integra?

On a 1994 Integra the neutral safety switch in located right above the clutch pedal under the dash(If you were to lay in the floor board with a flash light and press the clutch you should be able to see it). It's kinda hard to access because it so far up in there. so 9 times out of 10 the switch itself isn't bad there is piece of plastic that pushes in the neutral safety switch that is broken or fell off. It's cheaper and the switch will still work. I had this problem with my integra yesterday, it wouldn't start or turn over. So I had to go down the list of things it could be, then I found out where that switch was pushed it in and the car started right up no problem. Hope this was helpful to somebody. DarrenDizz


How do you change the key cylinder of the ignition switch in a 1991 acura legend?

Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.


How to install a boost gauge in a Acura Integra?

How to install a boost gauge in a acura integra?"


How do you install an after market stereo in a 1989 Acura Legend?

How do you install an after market stereo in a 1989 acura legend?


Where do you install a new flasher for a 92 Acura Legend?

where do you install a new flasher for a 1991 Acura Legend?"


How do you install a bank 1 sensor 2 for an 1998 acura tl?

how do you install a bank 1 sensor 2 for an 1998 acura tl


How do safety ratings for the Acura RSX compare to other cars in its class?

The safety ratings for the Acura RSX are very good,much better than most cars in its class. You can review the safety ratings for the Acura RSX and other vehicles at www.internetautoguide.com.


Where can i get an alternator installation diagram for a 1991 Acura Integra?

how to install a altinator on a 1991 acura integra


Where is the 1995 Acura Integra fan switch located?

The fan switch on a 1995 Acura Integra is located on the dashboard. It is a part of the temperature control system.