This is most likely the cable that runs from the speedo to the odo. As it ages, the lubricany dries up and the cable drags and sometimes starts to kink. You can replace this cable by removing the speedo cable from the head and the mount on the transmission (w/ the speed sensor)(mounted on the passenger side of the car right above the halfshaft). Remove the speed sensor and pull the cable out from the trans end. The new cable will be fed from the trans end back up to the speedo. Reattach the speed sensor and mount onto the trans. Install the cable back on the head and you shoudl good to go.
89 Speedo cableI just paid for a lower speedometer cable. The sensor began in '90. The part price was 35.78 plus shipping. It also has a sensor that sits on top of the transmission case. I'm ordering one from hondapartscheap.com today!To better answer the question, an 89 prelude has both. The speedometer cable attaches to the speed sensor.
I have a 1989 prelude si and im pretty sure there 15s
No. The 1989 Prelude's body style is different, and a little larger, than the 1984 body style.
Speedometer cable replace 1989 toyota
The 1989 Honda Prelude had 4x100mm offset. The 1989 Nissan 240sx has a 4x114.3mm offset...so, it will not fit.
How do i take the fuel filter off my honda prelude si 1989
The starter on the 1989 Honda Prelude is located on the left side of the engine. It is under the radiator hose that is at the rear of the radiator.
Yes, but it will require a large amount of customization.
None of the dashboard lights work on my 1988 Prelude. Why?
in the boot
Back of the speedometer, through the firewall and into the top of the transmission.
No, they are different.