0
Add your answer:
Earn +20 pts
How do you fix the timing chain 91caprice?
Fig. 11 Valve Timing MarksRemove engine front cover as outlined previously.Remove crankshaft oil slinger.Crank engine until timing marks on sprockets are in alignment, Fig. 11.Remove three camshaft to sprocket bolts.Remove camshaft sprocket and timing chain together. Sprocket is a light press fit on camshaft for approximately 1/8 inch. If sprocket does not come off easily, a light blow with a plastic hammer on the lower edge of the sprocket should dislodge it.If crankshaft sprocket is to be replaced, remove it with a suitable gear puller. Install new sprocket, aligning key and keyway.Install chain on camshaft sprocket. Hold sprocket vertical with chain hanging below and shift around to align the timing marks on sprockets.Align dowel in camshaft with dowel hole in sprocket and install sprocket on camshaft. Do not attempt to drive sprocket on camshaft as welch plug at rear of engine can be dislodged.Draw sprocket onto camshaft, using the three mounting bolts. Tighten to specifications.Lubricate timing chain with engine oil and install cover.
What do you call a large sprocket?
a large sprocket
When your in low gear what sprocket are you using?
It depends on whether you are talking about the front sprocket (the one at the pedals, called a chainring) or the sprocket at the rear derailleur. The lowest gear at the front is the smallest sprocket/chainring. The lowest gear at the rear is the largest sprocket. So if you combine the smallest sprocket at the front with the largest sprocket in the rear you have the lowest gear available on your bike.
What is the difference between sprocket and chain wheel?
Sprocket and chain and what?
What is the top speed of Honda 400ex with aftermarket rear sprocket?
depends if the sprocket is bigger or smaller than a stock sprocket.
How do you take a 250 kawasaki Mojave sprocket off?
first. take the left side rear wheel off. then remove the 4 bolts that hold the sprocket to the sprocket holder. then remove sprocket
What is a minimum plain bore sprocket?
A minimum plain bore sprocket is a roller chain sprocket with a hole drilled through the center. A finished bore sprocket is a roller chain sprocket with a hole drilled through the center augmented by either a keyway or set screws.
What type of simple machine is a bicycle sprocket like?
A sprocket is a lever.
What is a crank gear?
The sprocket on the nose of the crankshaft that drives the cam sprocket.
What was the name of the dog in Fraggle Rock?
The dog was called Sprocket :-)--true that sprocket is funny,cute,and amazing I heart dogs too!
When did Toad the Wet Sprocket end?
Toad the Wet Sprocket ended in 1998.
Can you put a 25t sprocket on a mongoose logo 2010?
yes it has a 26t sprocket
