remove front wheel and inner fender on the driver side. remove the kick panel on the inside. unbolt the cable handle. remove plastic cover from the hood latch and remove ball end of cable. unclip cable retainers, about 4 in the engine area( mark frame to identify holes before removing), 2 in the fender well. pull straight out and reuse. once cable is loose, cut cable, remove bracket and tape old cable to the new one, using it to pull new cable through all the holes to the front- easier than trying to snake it through. put it all back together. takes about an hour
How do you adjust the kickdown cable on a Honda Civic 2000 ex
There is no cable.... Its electronic.
Disconnect the cable from the Civic battery. Trace the wire to the other end, paying careful attention to the routing. Disconnect the cable at the far end, and pull the cable out. Put the new cable in following the same path. reconnect the cable ends.
Shift cable? or bar.
the first cable - after +
The latch itself is held on with bolts, easy enough to change. The release cable has to be fed down the inside of the rocker panel and into the trunk.
The hood release cable snakes into the cabin of the car through the firewall. To replace the cable remove the old wire. Zip tie the new cable to the old one and pull it out. This will easily snake the new cable into place. Install the new cable on the release and lever.
There is not speedometer cable on a 1996 Honda Civic. There is a throttle cable. Top replace this unhook it from the throttle body and gas pedal. Hook on the new cable to snake it through the firewall. Properly hook the throttle cable to the gas pedal and throttle body.
How do you change the choke cable on a 2000 Honda Rancher?
Where the cable hooks on to the transmission there should be a little screw what adjusts the cable.
http://wiki.answers.com/Q/Can_you_show_me_a_picture_of_where_my_speedometer_cable_is_on_my_2000_Honda_Civic_LX"
To replace the speedometer cable for the 1998 Honda Civic, first purchase the cable for about 7 to about 11 dollars. Then, remove the negative battery cable on the vehicle and open the instrument panel. Remove the three terminal connector from the speed sensor and replace it with the new one.